exj 8ea, JEEP Manuals, Electronic Service Manual (jeep cherokee xj do 2000)
[ Pobierz całość w formacie PDF ]
XJ
INSTRUMENT PANEL SYSTEMS
8E - 1
INSTRUMENT PANEL SYSTEMS
TABLE OF CONTENTS
page
page
REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
INSTALLATION
(1) Install the instrument panel center bezel on
the I. P. Be certain headlamp leveling switch electri-
cal harness is inserted through the hole in center
bezel.
(2) Connect the headlamp leveling switch electri-
cal.
(3) Verify switch / system operation.
(4) Install
HEADLAMP LEVELING SWITCH
REMOVAL
the
headlamp
leveling
switch
in
the
instrument
panel
center
bezel
by
gently
pushing
straight in.
(5) Connect the negative battery cable.
REAR FOG LAMP SWITCH
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO GROUP 8M - PASSIVE
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG
DEPLOYMENT
AND
POSSIBLE
PERSONAL
INJURY.
(1) Disconnect
and
isolate
the
battery
negative
cable.
(2) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the instrument panel cen-
ter bezel away from the instrument panel to release
the six snap clip retainers.
(3) Remove the center bezel from the vehicle.
(4) Remove the three screws that secure the acces-
sory switch bezel to the instrument panel
(5) Pull the accessory switch bezel out from the
instrument panel far enough to unplug the wire har-
ness connectors (Fig. 2).
(6) Remove the accessory switch bezel from the
instrument panel.
(7) Carefully pry the snap retainers at the top and
bottom of the rear fog lamp switch receptacle on the
back of the accessory switch bezel with a small thin-
bladed screwdriver and pull the switch out of the
receptacle.
Fig. 1 Headlamp Leveling Switch Position &
Orientation
1 – INSTRUMENT PANEL CNETER BEZEL
2 – HEADLAMP LEVELING SWITCH
(1) Disconnect
and
isolate
the
negative
battery
cable.
(2) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the instrument panel cen-
ter bezel away from the instrument panel to release
the four snap clip retainers (Fig. 1).
(3) Pull the center bezel away from the instrument
panel far enough to disconnect the wiring harness
from the headlamp leveling switch.
(4) Depress the switch retaining tabs to remove
the switch from the center bezel.
 8E - 2
INSTRUMENT PANEL SYSTEMS
XJ
REMOVAL AND INSTALLATION (Continued)
receptacle on the back of the accessory switch bezel
are fully engaged. Tighten the mounting screws to
2.2 N·m (20 in. lbs.).
Fig. 2 Accessory Switch Bezel Remove/Install
1 – ACCESSORY SWITCH BEZEL
2 – SCREW
(8) Reverse the removal procedures to install. Be
certain that both of the switch snap retainers in the
[ Pobierz całość w formacie PDF ]